Researchers in China have investigated how screen printing of photoresist degrades copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design to reduce the damage. The work addresses a manufacturing step that is important for lowering metallization costs and reducing reliance on silver.
Screen printing is widely used for solar cell metallization, but mechanical pressure and thermal treatments can damage sensitive passivating contact structures, increasing recombination losses and reducing conversion efficiency. The issue is particularly relevant for copper-plated HJT cells, which are seen as a promising route to cheaper metallization and less silver use.
Why photoresist printing differs
Corresponding author Lang Zhou said the photoresist screen-printing process differs fundamentally from conventional silver paste printing. In silver paste printing, screen openings account for only 2–5% of the total area, while an emulsion layer covers the rest and prevents direct contact between the mesh and the wafer. For full-area photoresist coating, screens typically omit emulsion coverage to ensure uniform resist deposition across the whole wafer, so the mesh comes into direct and extensive contact with the wafer during each printing cycle.
Previous investigations cited by the researchers showed conversion efficiency declining from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial production. Open-circuit voltage and fill factor accounted for most of the loss, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Wear at the mesh knuckles
Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, suggesting damage to the amorphous silicon/crystalline silicon interface.
An emulsion buffer layer
To prevent direct contact between the screen mesh and the wafer, the researchers developed an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios ranging from 2.9% to 16.6%. The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution.
An emulsion coverage ratio of 4.7% provided the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The researchers attributed the improvement to the emulsion layer preventing direct mesh-to-wafer contact and thereby reducing cumulative mechanical damage to the sensitive passivation layers.
Zhou said the findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells.
The results were presented in “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells,” published in Solar Energy.
Copper metallization momentum
The development comes amid growing interest in copper metallization as an alternative to silver-based contacts in HJT cells. In April 2026, researchers at China’s Nankai University developed a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating. The approach addressed adhesion, contact resistance and stability challenges at the ITO interface.
Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT solar cell. The silver-free device showed a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. The findings underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
