Instruments & Meters

Instron Highlights High Strain Rate Testing for More Representative Crash Simulation

A supplier application engineer says strain-rate-dependent material data can make simulation and material selection more representative.

Petra DahlbergOctober 25, 20265 min read7 views
A high strain rate test rig holds a composite specimen beside a monitor showing an abstract simulation mesh.

Instron application engineer and product specialist Andrea Incardona has set out how high strain rate testing can supply material data for simulation, material selection and product development, noting that quasi-static properties alone may not represent rapid impact or crash conditions.

In the article, Incardona says many materials have strain-rate-dependent properties, meaning their mechanical response can change as loading speed increases. A material characterised under quasi-static conditions may therefore respond differently during a rapid impact or crash event. Instron manufactures high strain rate testing machines; the account presents the company’s application perspective and cites external research rather than reporting a new independent test programme.

The article points to a 2025 study in the SAE International Journal of Materials and Manufacturing, “Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures.” According to the article, adding strain-rate-dependent material properties to crash simulations reduced differences between simulated and experimental results. The discrepancy in peak acceleration fell by 6.5%, while mean acceleration and displacement discrepancies fell by 5.9% and 6.3%, respectively.

Incardona says high strain rate characterisation can cover quasi-static conditions up to strain rates approaching 1,000/s, depending on the material, specimen geometry and test method. Such tests can last only 3 to 10 milliseconds, so data acquisition must capture rapid changes in force and deformation. Instron’s systems support acquisition at up to 200 kHz, and digital image correlation can provide additional information about strain development across a specimen, according to the article.

Dynamic data can also inform material selection. Conventional strength and stiffness values may not show how a material will respond when loading becomes rapid, and two materials that appear comparable in conventional tests may behave differently under high strain rate conditions. Characterising that behaviour can help engineers assess deformation, energy absorption and failure under conditions relevant to the application, the article states. This becomes more important when performance must be balanced against weight, as in automotive crash structures or aerospace components.

In product development, Incardona describes a connected process: measure material behaviour, incorporate it into simulation, compare design options and validate the result through physical testing. Used earlier, dynamic data can help engineers judge whether a material is suitable and refine a component design before final verification, according to the article. The value of the data, it says, depends on its relevance to the conditions a component will face, not simply on the quantity available. The account does not provide cost, throughput or adoption figures, nor does it reproduce the underlying study data.