Industrial Machinery

KraussMaffei Introduces Single-Stage PVC Roofing Membrane Extrusion Process

PVC InlineMixing replaces separate hot-cold mixing with direct gravimetric feeding and continuous twin-screw extrusion.

Priya RamanNovember 17, 20265 min read0 views
Concept illustration of a continuous PVC roofing membrane line, with gravimetric feeders, a twin-screw extruder and calender rolls forming a wide sheet.

KraussMaffei Extrusion has developed PVC InlineMixing, a continuous single-stage process for producing PVC roofing membranes. The system is designed to replace the conventional two-stage route in which PVC powder, plasticizers, additives and fillers are first blended batchwise in a separate hot-cold mixer to create a dryblend, then cooled, stored and later plasticized in a twin-screw extruder.

In the new arrangement, all solid and liquid components are fed directly into the extruder through gravimetric dosing systems. The material is heated once rather than being processed through a separate mixing and cooling cycle. According to KraussMaffei, this can reduce energy consumption and energy costs by up to 75 percent, depending on the formulation, system parameters and location.

Economic case

The company says removing the separate heating-cooling-mixing combination lowers capital expenditure because that equipment no longer has to be purchased. It also reduces floor space, labor requirements and maintenance related to wear parts in the hot-cold mixer. Combined with lower operating costs, the company argues that these changes improve overall cost-effectiveness and create conditions for a rapid return on investment.

The process also targets production flexibility. Formula adjustments and color changes can be made directly during operation through the integrated control system, according to KraussMaffei. That avoids the preparation and intermediate storage of separate dryblend batches, which the company identifies as time-consuming in the two-stage route.

Development and validation

PVC InlineMixing was developed at the KraussMaffei Extrusion Technology Center in Laatzen and tested with industrial roofing membrane formulations. The trials used a co-rotating twin-screw extruder from the ZE 65 BluePower series, equipped with loss-in-weight feeders for solid components and multiple liquid feeders for free-flowing formulation ingredients.

The ZE BluePower series has a Da/Di ratio of 1.65. KraussMaffei says the combination of high torque and large free volume provides a wide process window for different formulations. Tests confirmed what the company describes as excellent gelation levels and high product quality; mechanical properties and weldability also met industrial requirements across several formulations.

Industrial reference

The process is already in use in an industrial production line for PVC roofing membranes. The reference plant uses two extruders and two calenders to achieve a total throughput of 1,800 kg/h. PVC, additives and fillers, along with edge trimmings generated in the line, are continuously processed directly into finished membranes.

Christopher Bartel, head of sales for flat and foam at KraussMaffei Extrusion, says the approach offers manufacturers lower production costs, greater flexibility and more efficient manufacturing. In the company's account, users can respond more quickly to new requirements and adjust formulations during production while reducing energy and capital expenditure.

The significance of the development lies in compressing compounding and extrusion into a more continuous flow, but its benefits remain formulation- and site-dependent. KraussMaffei's 75 percent energy-saving figure is an upper bound tied to specific conditions, not a universal result. The reference line and validation work indicate industrial intent, while broader cost and quality outcomes will depend on each manufacturer's formulation, equipment configuration and operating practices.