Instruments & Meters

SinceVision launches SGI-N030W wide-spot laser displacement sensor

The SGI-N030W uses an expanded laser spot and dual-sensor synchronisation for micrometre-level measurement on battery electrodes, wafers and precision assemblies.

Nadia BelmonteNovember 17, 20265 min read0 views
Two compact laser sensor heads straddle a moving electrode web on a precision gantry in a clean industrial inspection setting, with a broad measurement spot illuminating the surface.

SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor intended for high-speed, non-contact dimensional measurement on rough, textured and irregular surfaces. The company says the sensor uses an expanded laser spot and optical triangulation to reduce instability that conventional point-spot systems can encounter when surface finish varies.

The SGI-N030W extends SinceVision’s SGI Series. It is aimed at lithium-ion battery manufacturing, semiconductor processing and precision mechanical engineering, where micrometre-level measurement is required. Conventional point-spot sensors concentrate reflected energy on a small area, so scratches, grain boundaries, brushed textures and matte finishes can create signal variations that are interpreted as dimensional changes. SinceVision says this can produce false defect warnings and additional inspection. The wide-spot configuration collects reflected light over a broader area and averages local microscopic peaks and valleys before signal conversion, reducing the influence of surface roughness and optical scattering on materials such as drawn metals, sandblasted surfaces and coated battery foils.

Specifications and interfaces

The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm on a diffuse white target under static conditions and linearity of ±0.02% of full scale. Sampling at 50 kHz, equivalent to a 20 µs update interval, is intended to support high-speed measurement and monitoring of dynamic processes. Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage. Master-slave synchronisation allows two sensors to operate in opposition and measure from either side of a component or moving material.

Battery electrode thickness

One principal application is in-line thickness measurement of lithium-ion battery electrodes, where coating thickness and uniformity affect energy density, internal resistance and long-term cell stability. SinceVision notes that offline contact micrometers or drop indicators can introduce operator variability and potentially deform wet or uncured electrode material, while periodic spot measurements cannot provide continuous coverage across a production reel. In the proposed arrangement, two synchronised sensors sit above and below a moving electrode web on a calibrated, low-thermal-expansion marble gantry. The opposing heads measure clearance to the material, and a controller combines those readings with the fixed mounting datum to calculate absolute thickness in real time. SinceVision reports production trials with stable, repeatable measurement within ±0.3 µm at a web speed of 300 mm/s. The 50 kHz sampling rate is intended to provide longitudinal resolution for detecting localised coating agglomerations, edge thinning and exposed substrate before cell winding.

Other target applications

The sensor is also intended for semiconductor manufacturing, where non-contact measurement is important for sensitive wafer surfaces. Potential uses include wafer position verification, edge detection, height measurement and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems. In precision assembly, it can monitor voice coil motors, linear actuators and micro-steppers. Its sampling rate enables capture of transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot across the measurement range, with position data sent to machine control systems through Ethernet for real-time monitoring and process control.

Jack Li, global sales and marketing director at SinceVision, says false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He says conventional point-beam sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing lines and creating manual inspection needs. The SGI-N030W’s expanded optical spot is designed to average those surface-related variations, while synchronisation between opposing heads supports high-speed thickness verification.